We offer clients a wide gamut of Hydraulic Power Press of both C-frame and H-frame types. It is sourced from trustworthy vendors of the market who manufacture it using premium raw material. Our Hydraulic Power Press comes in different capacities ranging from 10ton to 500 metric tons. Additionally, Hydraulic Power Press runs on high speed, with low maintenance and high performance. It is offered at nominal prices.
- CNC/Automatic high speed power presses : 12ton to 120tons
- C frame with air clutch
- C frame flywheel presses : 10ton to 75tons
- C frame back geared presses : 50ton to 450tons
- H frame with single and double connecting rod
- Straight side presses with single and double connecting rod : 50ton to 500tons
Crankshaft and Pitman running on roller bearings with fixed stroke
- Ram with backlash-free pre-loaded linear roller bearing guides,
- Air friction clutch with friction brake for short stopping distances andminimal stopping time.
- Minimal air consumption;
- Noise muffler on clutch exhaust.
- Drive and clutch are enclosed in sound dampeners and operate quietly, noise level under 85 dB(A) (measured after DIN 45 635) without tooling;
- Air service unit (lubricator - heavy duty filter - regulator);
- Air pressure control unit, adjustable, with emergency stop in case of insufficient air pressure;
- Flywheel rotation detector for set-ups;
- Machine bed with cross T-slots T 14 to DIN
- Machine base
- Interlocked Press Barrier guard.
- Infinitely variable controllable drive via frequency controlled three-phase AC motor for press speeds of 100 - 600 strokes/min.
- Mabu mPC-10 Electronic Press Control in a compact console, 4 line display for clear text information; incl. fully automatic TDC cut-off, operating hours counter, 2 programmable counters and 3-fold cam switching system. Operating modes: 0 – MANUAL SETTING UP – SETTIN UP by INCHING – SINGLE STROKING – CONTINUOUS OPERATION via
Lockable operating mode selection switch :
- crankshaft and connecting rod mounted in roller bearings
- fixed stroke, specified by customer between 20mm and 4Omm, .Slide is guided by backlash free preloaded linear 8-fold roller bearings. .single-disc friction clutch,
- frequency regulated 3-phase motor, speed range between 100 and 600 strakesimin
- modem C PC control (computer programmable control) mabu mPC-l 0 in freestanding control panel.
Powerful feed make this press the ideal solution for your production problems :
- High-performance gripper feed system mahu ZR 11 :
- A fully mechanica1u nit for the high estdemands, which runs absolutely synchronously with the automatic press.
- The slide operates according to an oscillating sine wave without any fixed stops and completely silently:
- Parallel clamping of materia1 with high gripping power using flat grippers.
- Mechanica1 intermediate lifting for pilot punch operation, infinitely adjustable,can be switched in or out.
CNC Roller Feed Unit :
- Programmable roller feed units, on request with easy-to-use control system for complete feeder programs.
- Upper and lower rollers driven with no play no increased play with roller lifting or with thick materials.
- Electra-pneumatic roller lifting for
- setting up and for intermediate lifting during pilot pin operation.
- Roller pressure can be sensitively and variably adjusted.
- 3-phase servo motor drive Incandescence a CNC a rouleaux